Yuga LPM2100 MG LTE NB-IoT Module

Yuga LPM2100 MG module is a two band NB-IOT IOT wireless communication module, which supports Band3, Band5, and Band8. It is mainly applied to low power data transmission service. Meet the 3GPP Release 13 standard. The Yuga LPM2100 MG module has 44 pins in all. The ultra-small size with 15.8mm*17.7mm*2.2mm can meet almost all M2M requirements. The Yuga LPM2100 MG module is a patch module. Using LCC package, Yuga LPM2100 MG module can be embedded in the customer's application by the pin welding disk. It can provide a rich hardware interface between the module and the client's main board. LPM2100 MG NB module uses low-power technology, standby power consumption is less than 1mA, deep sleep can be as low as 5uA.

Yuga LPM2100 MG NB-IoT module can be applied to the following situations:

* Smart city (intelligent parking, water/gas meter, street lamp, smoke alarm, garbage bin, etc.)

* Consumption and medical care (wearable devices, VIP tracking, life support, remote clinical tracking, etc.)

* Industrial and agricultural intelligent monitoring (machine alarm, gas detection, irrigation, soil pH value, etc.)

* Agriculture and environment (agricultural application, environmental monitoring, etc.)

* Logistics support (industrial assets, container tracking, location and status updates, etc.)

Yuga LPM2100MG Module Specifications:

* Category: LTE NB-IoT

* Form factor/package: LCC

* Physical characteristics 15.8mm*17.7mm*2.2mm

* Application processor: 192MHz MIPS processor with 16KB I-Cache and 16KB D-Cache

* Working voltage: 3.4V - 4.2V Typical voltage 3.7V

* Power saving: PSM mode power < 5uA

* Standby: Dormancy mode current < 1mA

* Application interface:
- Power interface
- Several general-purpose GPIO interfaces
- One standard SIM interface, support 3.0V/1.8V, support hot swap function *
- One Hardware reset interface
- Three UART serial port interface
- One SPI interface
- One Network state indicator interface
- One PSM_EINT# interface
- One ADC detection interface

* Working band:
- Tri-frequency: Band3, Band5, Band8
- The module can automatically search frequency bands, and the band selection can be set by AT command. Need to correspond to a specific version

* Network protocol characteristics:
- UDP/TCP/CoAP/LWM2M
- PPP/SSL/DTLS/FTP
- HTTP/MQTT/HTTPS

* Data transmission characteristics
- Single-tone:25.5kbps(DL),16.7kbps(UP)
- Multi-tone:25.5kbps(DL),62.5kbps(UP)

* Antenna interface:
- 50 Ω interface of the main antenna
- 50 Ω interface of Bluetooth antenna

* Firmware update: Serial port upgrade

* Temperature range:
- Normal working temperature - 20℃ to +70℃
- Limit working temperature - 40℃ to +85℃
- Storage temperature: -45℃ to +90℃

* AT command: Support standard AT command set (Hayes 3GPP TS 27.007 and 27.005)